In daily use, the kitchen sink will inevitably have a situation where the water cannot flow, that is, the kitchen sink is blocked. How to deal with a clogged kitchen sink?
First, turn off the tap faucet, don't think about boiling water to flush down the impurities in the sink, that will only lead to a large amount of water storage.
Second, first look at what is the sink blocked, generally all blocked in the U-shaped bend, some sewer pipes will contain sewage treatment screws, just twist it open, and then apply stainless steel wire to the two sides down on it.
If it still can't be treated, you can unload all the sewer pipes, twist all the plastic connectors, clean the internal impurities and assemble them one after another, so that it can be taken down in less than half an hour.
Third, for the drainage pipe of the pool or washing tank to see that there is no obvious blockage, you can use a wet rag to plug the overflow hole, and then use a hammer to remove the sediment.
If the blockage cannot be cleaned up, a bucket can be placed at the water storage bend of the drain pipe, and then the bend can be unscrewed to remove the blockage inside.
Fourth, the general sewer pipes are all blocked by greasy, and you can boil a pot of boiling water to lead into the water pipe before dredging to make it easier to dredge.
When dredging, you can use your hand or a special tool such as a hook to reach into the drain pipe to eliminate the dirt and impurities blocked in it.
If you are a resident on the first floor, you should check whether the outdoor sewer pipe is full of dead leaves or sludge, which blocks the drainage pipe.
Fifth, if the blockage problem cannot be dealt with, this indicates that this sediment is blocked in the deepest part of the pipeline, which is not an area that ordinary people can remove, and the maintenance worker should be notified immediately to solve it, so as to avoid long-term blockage and water accumulation in the pool.